Operations; Powering On Batteries - Huawei SmartLi User Manual

Table of Contents

SmartLi

User Manual

Prerequisites

Turn on the ready switch on the battery management module.

Procedure

Step 1 On the UPS LCD screen, set System Info > Settings > Battery Settings > Battery Type to

Lithium battery.



Step 2 Press and hold the POWER ON/OFF button on the battery management module for more than

2s. The green indicator of the battery management module blinks at 4 Hz.



Step 3 Set the language, time, date, network parameters, and system parameters on the Settings

Wizard screen

Issue 04 (2019-09-16)

Upgrade the UPS software to the version that supports lithium battery connection. See

UPS5000 The Relationship of Software Version to check the version number.

Thres. of low batt. volt. over dry contact (V/cell): If you set Batt. Volt. Below

Threshold for an output dry contact and the battery voltage is lower than this threshold,

the output dry contact will output signals accordingly.

The BCB off alarm is displayed on the UPS LCD and SmartLi LCD. No action is required.

After the battery circuit breaker is closed, the alarm is automatically cleared.

After the battery management module is started, the green indicator is on for 1s and then

off for 4s, and the yellow indicator is steady on.

If multiple SmartLi cabinets are combined, press and hold the POWER ON/OFF button on

each battery management module of the cabinets one by one for more than 2s.

Operations

5 Operations

Table of Contents