Figure 4-3 Schematic Representation Of A Single Drive - Siemens SIMOTICS HT Series Operating Instructions & Installation Instructions

①
②
③
Figure 4-3
NOTICE
Bearing damage
The bearing insulation must not be bridged. Damage may be caused to the bearings if there
is a flow of current.
● Also when performing subsequent installation work, e.g. installing an automatic lubrication
● Contact your Service Center, if necessary.
See also
Service and Support (Page 117)
SIMOTICS HT Series HT-direct 1FW4...1......A
Operating Instructions 11/2018
Driven machine
Motor
Coupling
Schematic representation of a single drive
system or a non-insulated vibration sensor, ensure the bearing insulation is not bridged.
4.13 Converter operation
④
Insulated bearings
⑤
Insulated tachometer mounting
Preparations for use
43