Attach to Rear of Cart Leave 20" (508 mm) of cable slack to allow cart to raise and lower through its full range of motion. END OF INSTALLATION 3 of 6 888-97-392-G-00 rev. C • 08/19...
Page 4
Attach to Front of Cart (Only for carts with no drawers) M6 x 10mm Attach the Travel Stop bracket to the lift engine to keep SV DC Power System from hitting the base. M3 x 25mm Route cables with wrap and ties. 4 of 6 888-97-392-G-00 rev.
Page 5
Attach to Front of Cart (Only for carts with no drawers) Adjustment Step It is important that you adjust this product according to the weight of the mounted equipment as described in the following steps. Any time equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and optimum operation.
Need help?
Do you have a question about the SV DC Power System and is the answer not in the manual?
Questions and answers