First Time Operation - MB Connect Line mbNET.rokey Series Quick Start Up Manual

8

First time operation

Connect, depending on device type, an antenna, and insert a SIM card.
Before connecting the router to a network or PC, first ensure that it is properly connected
to a power supply, otherwise it may cause damage to other equipment.
• Connect equipotential bonding
to the grounding lug on the router's top panel.
• Connect the (10-30V DC) power supply to the
X1 terminal of the router.
Make sure that the polarity is correct.
◦ After switching on the supply voltage the Pwr LED lights up and the device performs
a system check.
◦ After about 90 sec., both LED Pwr and Rdy light up and Fc1 is flashing green (5 Hz).
The flashing LED Fc1 signals that the function SIMPLY.connect *
is ready but not yet activated.
To activate the function, press the Dial Out button until Fc1 lights up.
=>
Fc1 Fc2
If you do not want to use the function, simply ignore the flashing LED Fc1.
*SIMPLY.connect is a web application that helps you to set up a device (mbNET)
The mbNET is now ready for operation.
=
Dial Out
More information is available at: https://simplyconnect.mbconnectline.com/
Fc1 Fc2
in the Remote Service Portal mbCONNECT24.
- 15 -
X1
X2 galvanically isolated
+ - I4 I3 I2 I1 P M O2 O1
Fc1
Fc3
Rdy
Pwr
Fc2
Fc4
Con
Stat