Cisco Network Convergence System 6000 Series Unpacking, Moving, And Securing Manual page 33

Unpacking the Chassis
Note The brackets are labeled as left or right (viewed from the front and rear).
Figure 14: Lift Brackets and Bolts
1 From left to right—left front and right front lift
brackets
2 Side pins on each lift bracket (inserted into the
chassis)
3 From left to right—right rear and left rear lift brackets
4 Eight M14 x 30 mm socket-head cap screws (used to
bolt the front and rear lift brackets to the dolly)
5 Four M10 x 25 mm socket-head cap screws (used to
bolt the front and rear lift brackets to the chassis)
Step 4 Attach lift brackets to the chassis by using the M10 x 25 mm bolts and 17-mm socket
). Align and insert the side pins of the lift bracket to the lower left side of the front side of the chassis.
Step 5 Repeat this step with the right lift bracket on the lower right side of the front side of the chassis.
the Lift Brackets to the Chassis (Oblique View)—Cisco NCS 6008 Chassis Shown
Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide
Attaching the Dolly to the Chassis and Removing the Chassis Pallet
6 Hole for M10 x 25 mm socket-head cap screw
7 Left front
8 Right rear
9 Right front
10 Left rear
(Figure 14: Lift Brackets and Bolts
shows the oblique view of attaching
Figure 15: Attaching
25