Cisco Network Convergence System 6000 Series Unpacking, Moving, And Securing Manual page 32

Hide thumbs Also See for Network Convergence System 6000 Series:

Table of Contents

Attaching the Dolly to the Chassis and Removing the Chassis Pallet

Step 2

Use the 3/8-inch ratchet wrench and 9/16-mm socket to remove the two dolly-to-chassis lift brackets. Repeat this step

for the second dolly unit.

Figure 13: Install Lift Brackets from Dolly

Lift bracket

12-mm hex bit

Note

The lift brackets must be attached to the chassis

first.

Step 3

Select a lift bracket. There are two identical lift brackets for the right front and left rear and two identical lift brackets

for the right rear and left front.

Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide

Two lift bracket side pins on the removed lift bracket

Unpacking the Chassis

Table of Contents

Need help?

Do you have a question about the Network Convergence System 6000 Series and is the answer not in the manual?

Ncs 6000 Ncs 6008