Steps
Step 5
Remove the large side panel of the wooden enclosure and set it aside carefully.
When setting aside the box, be careful to rest the wood on the floor so that the metal lock latches are not bent
Note
or otherwise damaged. On most of the wooden enclosure, there should be rubber bands above the bottom lock
latches to hold them up so that they do not get damaged when setting the enclosure down.
Step 6
Remove the remaining bottom screws on each side of the plywood box
Step 7
Using at least two people, one on each side of the box, lift and remove the three-sided box and place it aside.
Step 8
Remove the protective shipping bag from the chassis. Do not remove the bag until you are ready to move and install the
chassis
The following figure shows the wooden box removed from the chassis and its protective bag.
Figure 10: Chassis Shipping Box Removed and Chassis Shipping Bag
1
Chassis pallet
Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide
20
(Figure 8: Cisco NCS 6000 Series Chassis
3
Protective bag over chassis
Unpacking the Chassis
Crate).