Dolly Specifications; Unpacking The Dolly - Cisco Network Convergence System 6000 Series Unpacking, Moving, And Securing Manual

Overview
3

Dolly Specifications

The optional dolly that is available for the Cisco NCS 6000 Series chassis is flexible enough to meet several
challenges common when first positioning a chassis of this size and weight. Such challenges include limited
hallway or doorway width, doorway thresholds, ramps, and tight corners along the transport route. To overcome
these challenges, use the dolly in either of the following configurations:
• The 90-degree configuration — The dolly assemblies are shipped in this configuration. In some cases,
• This 180-degree configuration — This configuration is a more stable configuration for transporting the
Note The optional Cisco NCS 6000 Series Routers lift dolly is available from Cisco (PID NCS-LIFT). If you
already have a CRS lift dolly, you can order PID NCS-LIFT-BRKT, which is the CRS lift upgrade to the
NCS lift dolly.
The following table lists the specifications for the Cisco NCS 6000 Series chassis lift dolly.
Table 3: Cisco NCS 6000 Series Lift Dolly Specifications
Specification
Weight (each component)
Maximum recommended safe curb height

Unpacking the Dolly

We recommend that you use a dolly to move the chassis. The dolly is an optional item that you can order
from Cisco. The shipping crate contains the dolly units, positioned in the 90-degree configuration
Removing the Chassis Dolly Shipping
dolly units.
Primary LCC/FCC mount locations (preferred
location)
this configuration is needed to transport the chassis. Use the 90-degree configuration
Dolly—90-Degree Configuration
configuration so that the chassis does not tip too far and fall during transport.
chassis. We recommend using the 180-degree configuration
Configuration ) for moving the chassis, although both configurations are acceptable to transport the
as-shipped chassis.
Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide
) to move the chassis off the pallet. Take extra care when using this
(Figure 6: Chassis Dolly—180-Degree
Value
126.0 lb (57 kg)
1.5 in. (3.8 cm)
Container). This section describes how to unpack and position the
Dolly Specifications
(Figure 5: Chassis
(Figure 3:
5