Yamaha CL3 Service Manual page 35

Digital mixing console
Hide thumbs Also See for CL3:
Table of Contents

Advertisement

A-17. OPT Circuit Board
(Time required: About 7 minutes)
A-17-1. Open the control panel U5 assembly and secure with
the service stays. (See procedure 1)
A-17-2. Remove the three (3) screws marked [190].
(Photo 20)
A-17-3. Remove the three (3) hooks marked [E]. The OPT
circuit board can then be removed. (Photo 20)
A-18. LAMP Connector Assembly
(Time required: About 9 minutes)
A-18-1. Open the control panel U5 assembly and secure with
the service stays. (See procedure 1)
A-18-2. Remove the rear upper U5 sub assembly.
(See procedure A-1)
A-18-3. Remove the two (2) screws marked [1050]. The
LAMP connector assembly can then be removed.
(Photo 18)
A-19. TBPHN Sheet Assembly
(Time required: About 8 minutes)
A-19-1. Remove the control panel U5 assembly.
(See procedure 1)
A-19-2. Remove the two (2) knobs marked [620].
(Photo 21)
A-19-3. Remove the two (2) hexagonal nuts marked [580].
(Photo 21)
A-19-4. Remove the three (3) screws marked [600A] and the
three (3) screws marked [600B]. The TBPHN sheet
assembly can then be removed. (Photo 21)
[E]
Photo  20  ( 写真 20)
[80]
OPT
A-17. OPT シート
(所要時間:約 7 分)
A-17-1. コンパネ U5  Ass y を開けて、サービスステイで固
定します。 (1 項参照)
A-17-2. [80] のネジ 3 本を外します。 (写真 20)
A-17-3. [E] のフック 3 箇所を外して、OPT シートを外し
ます。 (写真 20)
A-18. LAMP 線材 Ass y
(所要時間:約 9 分)
A-18-1. コンパネ U5  Ass y を開けて、サービスステイで固
定します。 (1 項参照)
A-18-2. リア上パネ U5 サブ Ass y を外します。 (A-1 項参照)
A-18-3. [1050] のネジ 2 本を外して、線材 Ass y  (LAMP)
を外します。 (写真 18)
A-19. TBPHN シート Ass y
(所要時間:約 8 分)
A-19-1. コンパネ U5 Ass y を外します。 (1 項参照)
A-19-2. [620] のノブ 2 個を外します。 (写真 21)
A-19-3. [580] の特殊六角ナット 2 個をを外します。 
(写真 21)
A-19-4. [600A] のネジ 3 本と [600B] のネジ 3 本を外して、
TBPHN シート Ass y を外します。 (写真 21)
TBPHN SHEET ASSEMBLY
(TBPHN シート Ass y)
[600B]
[580] [620]
[600A]
Adjust the cord holder so that the cord is about 10mm apart from the
PHONE jack (so that the cord will not contact IC911 on the other side).
束線をPHONEジャックから10mm程度離すよう束線止めにて成
形すること (反対側のIC911に束線が接触しないようにすること)
Photo  21  ( 写真 21)
CL3/CL1
[600B]
[600A]
[620] [580]
CORD HOLDER
IC911
(束線止め)
PHONE JACK
(PHONEジャック)
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cl1

Table of Contents