Description Of The Module; Electronics Board - Satel INT-GSM Manual

SATEL

3. Description of the module

3.1

Electronics board

antenna cable (the antenna is delivered with the module).
slot in which the second SIM card is to be installed.
slot in which the first SIM card is to be installed.
Inserting the SIM card into its slot before programming the card PIN code in the
module is not recommended (if the card requires entering the PIN code).
SIM1 LED. The LED is on, when the card installed in the SIM 1 slot is active.
SIM2 LED. The LED is on, when the card installed in the SIM 2 slot is active.
BUS LED. Flashing when data exchange with the control panel is in progress.
LOG LED:
ON – power OK,
flashing – communication via the module in progress.
RS-232 port.
pins for setting the module address (see "Setting address" p. 6).
Description of terminals
– power input (12 V DC ±15%).
+12V
– common ground.
COM
INT-GSM
Fig. 3. INT-GSM module electronics board.
5