Replacing The Platen Roller - SATO CL4NX Plus Operator's Manual

Replacing the Platen Roller

You can easily remove and replace a damaged or worn platen roller.
• Do not power on or off the product, connect or disconnect the power cord while your
hands are wet. Doing so could cause an electric shock.
• Disconnect the power cord from the AC outlet before you replace the platen roller.
Guideline to Replace the Platen Roller
The platen roller has a striped marking on the left side. When the striped marking started to fade off, it
indicates that you should replace the platen roller.
• This is only a general guideline. The condition in which the platen roller wears out
varies depending on the used media. In any cases, replace the worn platen roller when
it affected the printing quality of the product.
1. Make sure that the product is powered off, and disconnect the power cord from the
AC outlet.
2. Open the top cover.
• Open the top cover fully to prevent accidental drop of the cover.
3. Push the head lock lever (1) towards the rear to unlock the print head.
• The print head and its surroundings are hot after printing. Be careful not to touch it, to
avoid being burned.
• Touching the edge of the print head with your bare hand could cause injury.
690
Replacing the Platen Roller