Advertisement
VL800 EVENTWASH
To install in truss:
Step 1.
Lift luminaire into mounting position.
Step 2.
Secure in place with clamp handle. Ensure clamp handle hardware that Quick-lock fastener hook in
place (e.g.. wing bolt) is properly tightened and that luminaire is fully supported.
Step 3.
Attach safety cable (as required) as follows:
a.
b.
SAFETY CABLE: Recommended for hanging installations. May be required by local codes. Safety cable is sold
separately.
NOTE: Truss hooks shown are sold separately. Truss and pipe by others.
Step 4.
Make sure hanger is disengaged so luminaire moves freely.
Step 5.
Connect power and data cables according to procedure given in
When hanging the luminaire in a side hang position, natural convection and the designed direction of the inlet
and exhaust cooling fans dictate that the inlet should be closest to the fl oor and the exhaust should be towards
the ceiling. This eliminates the possibility of one luminaire blowing exhaust air into the inlet of the luminaire next
to it when the luminaires are side-by-side.
If the luminaires are stacked on top of one another in a side hang, a 45° enclosure orientation with the fan inlet
closest to the fl oor.
MENU OPERATION
LCD DISPLAY AND MENU SYSTEM
The VL800 Eventwash Luminaire's LCD Display and Menu System provide local control for accessing the follow-
ing fi xture's settings:
• Address – to set the DMX address
• Confi gure – various parameter settings, set LED, movement, display, reset defaults
• DMX – change the map, set address,
• Fixture – fi xture status, ReCal, reboot, software version, view fi xtures hours, crossload, service
• Test – to test functions of parameters
• Manual – to set the intensity, all functions
The menu system is controlled at the Menu Display available at the enclosure input panel. If there are multiple
luminaires in a system, any settings or changes would need to be made at each LCD Menu as desired.
Loop safety cable at least once around safety cable anchor point rod.
Loop safety cable at least once around truss/pipe and secure around pipe.
NOTE: The safety cable anchor point
is tested and is in compliance with
IEC / EN 60598-1:2015
Safety Cable Anchor Point
4
QUICK START GUIDE
Connecting Data on page
2.
Advertisement
