Table of Contents
Advertisement
Quick Links
VL800
EVENTPROFILE
This document provides basic setup instructions and safety
warnings for the following product(s):
91200545005
VL800 EVENTPROFILE
POWER AND DATA
CONNECTING POWER
The luminaire requires standard AC power distribution from 100-240 VAC, 50/60 Hz. Current required depends
on the AC supply voltage and product model.
NOTE: The mating power connector is supplied; however, you will need to purchase or construct a cable ap-
propriate for your application.
Depending on the application, the luminaire's AC input cable may require a diff erent connector. If required,
install a new connector meeting your requirements using the included wire color code reference.
WIRE*
green / yellow
blue
brown
*International (harmonized) standard
WARNING! DO NOT connect to three-phase service in countries with 240 volt power.
For single-phase power at 240V RMS:
CONNECTION
AC neutral
AC line
Ground (earth)
©2019 Signify Holding. All rights reserved.
FIGURE 1.
CONNECTION
Ground (earth)
AC neutral
AC line
PIN
X
X
Y
G
Y
INCLUDED ITEMS
QUICK START GUIDE
(this document)
VL800 EVENTPROFILE
AC power input
POWER CONNECTOR
For three-phase power at 200V RMS:
CONNECTION
Phase 1
G
Phase 2
Ground (earth)
1
QUICK START GUIDE
WARRANTY CARD
POWER CONNECTOR
CLAMP
PIN
X
X
G
Y
G
Y
W W W.VA R I - L I T E . C O M
Advertisement
Table of Contents
Related Manuals for Vari Lite EVENTPROFILE VL800
Summary of Contents for Vari Lite EVENTPROFILE VL800
-
Page 1: Connecting Power
QUICK START GUIDE VL800 EVENTPROFILE INCLUDED ITEMS This document provides basic setup instructions and safety warnings for the following product(s): 91200545005 VL800 EVENTPROFILE WARRANTY CARD POWER CONNECTOR CLAMP QUICK START GUIDE (this document) VL800 EVENTPROFILE POWER AND DATA CONNECTING POWER The luminaire requires standard AC power distribution from 100-240 VAC, 50/60 Hz. -
Page 2: Current Vs. Voltage
QUICK START GUIDE WARNING! Do not power any Vari-Lite luminaire from a dimmer - even in ‘NONDIM’ mode. Dimmer and non- dim modules are not suitable sources of power because their output modifi es the AC wave form. This may work for a short time, but will eventually result in power problems, luminaire error and/or failure and may void the luminaire’s warranty. -
Page 3: Hanging The Luminaire
VL800 EVENTPROFILE QUICK START GUIDE HANGING THE LUMINAIRE The VL800 EVENTPROFILE Luminaire can be hung hori- zontally or vertically from any structure designed to work with the type of load created Clamp and Quick lock fasten- er or other mounting hardware are required. Many compat- ible truss hooks are available from diff erent manufacturers for your particular needs. -
Page 4: Menu Operation
VL800 EVENTPROFILE QUICK START GUIDE FIGURE 4. SAFETY ANCHOR When hanging the luminaire in a side hang position, natural convection and the designed direction of the inlet and exhaust cooling fans dictate that the inlet should be closest to the fl oor and the exhaust should be towards the ceiling. -
Page 5: Dmx Address
VL800 EVENTPROFILE QUICK START GUIDE MENU OPERATION The LCD Display Menu system consists of several categories. Use the Menu Buttons to access and make changes to the menu items. When the desired menu item is reached, press the desired Menu Button to display the menu options and to navigate and confi... - Page 6 VL800 EVENTPROFILE QUICK START GUIDE QUICK REFERENCE DMX MAP 16-BIT ENHANCED 16-BIT CLONE MODE Intensity High Intensity High Intensity High Intensity Low Intensity Low Intensity Low Pan High Pan High Pan High Pan Low Pan Low Pan Low Tilt High Tilt High Tilt High Tilt Low...
- Page 7 VL800 EVENTPROFILE QUICK START GUIDE...
-
Page 8: Safety Warnings And Notices
LIMITED 2-YEAR WARRANTY Vari-Lite off ers a two-year limited warranty on its control products against defects in materials or workmanship from the date of delivery. A copy of Vari-Lite two-year limited warranty containing specifi c terms and conditions can be obtained from the Vari-Lite website at www.vari-lite.com...