Trouble Shooting - Adam Equipment PTS plus Series User Manual


After pressing [Tare] ↵, 'noload' should appear on the display. Use the
directional button ⭡ to switch to 'load1' and set the desired weight limit of the
test object to be placed on the scale using the ⭡ or ⭣ directional buttons and
the ⭢ directional key to move to the next digit. Press the [Tare] ↵ key to
confirm.

After pressing [Tare] ↵, 'Load' will appear on the display. Place the
calibration test weight that matches the weight previously entered onto the
scale weighing pan and press the [Tare] ↵ key to confirm.

Pressing Tare should bring up the 'Load 2' option on the display. Follow the
same procedure as before by setting a new weight and adding the
appropriate calibration weight and press the [Tare] ↵ key to confirm.

Pressing [Tare] ↵ will reconfigure the scale and bring the user back to the
regular weighing mode.
6.0

TROUBLE SHOOTING

No. Problem
Forks cannot ascend
to the maximum
1
height
Forks can not be
2
raised
Forks can not
3
descend
4 Oil spillage
Forks descend
when the trigger is
5
not in descend
position
Cause
Inadequate hydraulic oil in the
chamber.
No hydraulic oil.
Oil is not clean.
Position of the goods are to one
side of the truck
Aging or damaged seals.
The oil could be unclean
Some parts of the hydraulic
system are damaged.
Solution
Refill oil chamber. See Figure 1.
Refill oil chamber. See Figure 1.
Change oil
Relocate load.
Call for Service.
Change the oil.
Vent the air.
Call for Service.