Installation And Connection; Installation Requirements - zika I-PLAS60 User Manual

continuouslyoverrunning the rated load may lead to overheating of the machine and frequently
using the machine overrunning the rated load may accelerate the aging of the machine or even
burn the machine.
2) Output characteristics

2. INSTALLATION AND CONNECTION

2.1 Installation requirements

1) Environment requirements
a) Do not install the machine at places with excessive dusts and metal powders.
b) Do not install the machine at places with corrosive or explosive gas.
c) The temperature of the working environment should be between -10℃ and 40℃ .
d) Do not carry out cutting with the cutting machine placed on a platform with a pitch greater
than 15°.
e) The machine should be installed in a well-ventilated place with humidity of 90% or less and
without water condense.
f) Pay attention to the wind at the cutting site, and use wind deflector if necessary. Otherwise,
Figure 1-4: Duty cycle
Figure 1-5: Output characteristic curves