Equipment Installation; Working Place; Electrical Input Connection And Requirement Distribution - zika I-TIG200DC Owner's Manual

EQUIPMENT INSTALLATION

Warning --------Improper installation and connection will cause the equipment damage and personal injury.
Advice: The electric connection of equipment must be performed by qualified electrician holding qualification certificate.
3.1 Working Environment
TIG series welding machine should be used in recommended environment. Insulation work must be done in advance when
the following or similar instance exists:
a. When the operator's action is limited by environment (such as: only work on bended knees, on foot or lay), it must avoid
directly contacting the current-carrying part on equipment with body.
b. In the event the operating environmental space is very narrow and small so that the operator can not step aside the
current-carrying conductor, or in humid environment, the operators easy to sweat which make them in great electric shock
risks

3.2 Working Place

Ensure the welding machine is placed according to the following instructions
1. Dry and dust environment.
2. Ambient temperature: within 0℃- 40℃.
3. Without oil sludge, water vapour and corrosive gas.
4. No vibration and strike.
5. In rainproof and shade place.
6. More than 300mm to wall to ensure cooling air flow not be blocked and excellent ventilation.
3.3 Electrical Input Connection and Distribution Requirement
Warning ---------Electric shock may cause death.
High voltage direct current still exists in equipment after power-off, please do not touch the current-carrying part of equipment.
Shutoff welding machine power, remove fuse, and stick red warning mark on disconnecting switch.
Warning --------Do not connect the power line (red / white wire) to ground terminal.
Welding equipment is powered by single-phase (or three-phase) 50 / 60Hz AC power source. For the input voltage and
fluctuation range, please see the parameters listed on nameplate. Please select power supply voltage strictly according
to nameplate.
Caution: Improper power supply voltage may damage equipment.
Remark: This equipment is furnished with electric outlet which must be correctly connected by qualified
electrician according to specification.
USER'S MANUAL
Do not connect the ground wire (olivine wire) to power line.
10 I-TIG200DC