Operation; Panel Functions Of I-Plas60 - zika I-PLAS60 User Manual

to the"operation" chapter.
2) Installation of the cutting torch
Selecting wearing parts
A complete set of wearing parts for cutting are attached to the cutting torch A141, including the
wearing parts installed on the cutting torch and the spare electrodes and nozzles contained in
the wearing parts package.
Standard wearing parts for cutting torch A141 are recommended in order to obtain optimal
cutting quality.
3) Installation of the wearing parts
Plasma arc will be produced at the moment after the cutting torch is started,
so make sure that the power is cut off before replacing the wearing parts.
Turn the power switch to "OFF" position, install the complete set of wearing parts of the cutting
torch, including the fixing frame, fixing cover, nozzle, swirl ring and electrode, according to the
figure below.

3. OPERATION

3.1 Panel functions of I-PLAS60

WARNING: Plasma arc may cause burns or scalds during the
instantaneous start of cutting torch.
Figure 2-3: Wearing parts of the cutting torch