Setup; Installation - Hall Research Technologies UHB-SW2 User Manual

3.0 Setup

Installation


Connect the video source(s) to the UHB-SW2-WP transmitter.

Connect the USB Host (PC) to the transmitter using a USB A/B cable.

Connect the display to the UHB-R receiver.

Connect the USB devices to the receiver.

Optionally, connect the RS-232 or IR detector/emitter pair to extend
control signals between transmitter and receiver.

Connect CAT6 or better cable between transmitter and receiver.
NOTE Do not exceed 40m/131' if the extender is to be used with
4K UHD. Otherwise, do not exceed 70m/230' total length,
including patch cables. If using shielded cable, ensure
shields are connected to shielded connectors at both ends.

Plug in the supplied power supply to the receiver. The transmitter will
receive its power through the CAT6 cable.
HDMI/VGA Auto-Switching Wall Plate with USB
© Copyright 2019 Hall Research, LLC.
5