Table of Contents
Advertisement
CHAPTER 3 - KEYPAD OPERATING INSTRUCTIONS
T
he keypad consists of the 16 buttons on the front of the display,
and is used for the following functions:
1. To show inches, temperature, alarm status, and battery
condition as described in the previous chapter.
2. To turn on the backlight.
3. To test the alarms.
4. To turn the gauge display on or off.
5. To select Fahrenheit or Celsius for the temperature display.
6. To program the SMS phone number for alarm updates.
(901 only)
7. To set gauge identification numbers of each tank.
8. To view the satellite IMEI identification number. (904 only)
9. To view the last eight radio error codes.
10. To view radio signal strength level. (901,902,904 only)
11. To set the serial communication on or off.
12. To set the alarm points.
13. To select SMS phone on or off. (901 only)
14. To select data upload on or off. (901,904 only)
15. To set the gauge offset (the zero point).
16. To enter a linear calibration factor for the volume display.
17. To enter a point by point calibration table for the volume
display.
18. To allow the memory to be copied or programmed remotely.
19. To set the serial output to match optional board installed.
20. To select satellite data logging on or off. (904 only)
21. To view satellite diagnostic values. (904 only)
22. To set the cellular TCP address destination and port. (901 only)
23. To enter the 4 digit short user code which permits access to
functions 4 to 10 only.
24. To enter the 6 digit long user code which permits access to
functions 11 to 14 only.
25. To enter the 8 digit master code which permits authorized
personnel to set the user codes and to access functions 15
to 22.
Page 8
900D6D Manual
Advertisement
Table of Contents
