StewMac ’64 REVERB UNIT Assembly Instructions Manual page 24

STEP 53
Add four back-of-board jumpers
Flip the board over and add a 2-1/2"
white jumper between eyelets 13
and 23 .
Add a 1-3/4" white jumper between
the back of eyelet 3 and the back of
eyelet 18 .
Add a 4-1/2" white jumper to the back
of eyelet 5, then thread the other end
through the bottom of hole 27 and
pull it tight to keep it in place .
Add a 3-3/4" white jumper to the back
of eyelet 21, then thread the other end
through the bottom of hole 28 and
pull it tight to keep it in place .
stewmac.com
STEP 54
Add six jumpers
Add a 2-1/2" white jumper to eyelet
34 .
Add a 2-3/4" white jumper to eyelet
33 .
Add a 3" white jumper to the bottom
of eyelet 24, then thread the other end
up through hole 26 and pull tight to
keep in place .
Add a 5" green jumper to eyelet 4 .
Cut two 3/4" white jumpers and
remove their insulation . Add one
between eyelets 1 and 2 . Add the
second between eyelets 18 and 24 .
22
STEP 55
Review your work
All the components and wires are now
on the eyelet boards . Take a break to
rest your eyes . It's time to inspect your
work so far, and it's a mistake to do
that in a rush .
Review everything to make sure
you've correctly followed each step .
To find no mistakes at this stage is
pretty unusual, and it's much easier
to correct them now than after you're
done soldering!
As you check your
work, make sure
every connection
is tight!
© 2018 StewMac