3.3 Connect Cables
3.3.1 Ethernet Cable
Follow these steps to attach the Ethernet cable to the eNB.
1. Unscrew 3 screws on the cover of the wiring cavity (Figure 3-6) using M4 cross
screwdriver, and open the wiring cavity cover.
Figure 3-6: Wiring Cavity
2. Connect the Ethernet cable to the ETH interface in the wiring cavity.
3. Lay Ethernet cable along the wire groove, stretching it outside the wiring cavity.
4. The other end of the Ethernet cable connects to the PoE port on the power adaptor.
The LAN interface connects to a switch or other LAN device.
3.3.2 Connect Ground Cable
Prepare the grounding cable according to the actual requirements of the specific site. Refer to
specifications given in
bottom of the eNB, as shown in Figure 3-7. Unscrew the grounding screw, connect one end of
the grounding cable to the grounding screw, and fasten it again. The other end of the ground
cable needs to connect to a good grounding point.
Figure 3-7: Grounding Screw
section 3.3 Materials and
Tools. The grounding screw is located on the
15