Wiring; Bed With 24 V External Power Supply; Installing Aria And Bella Side Rail - Invacare Medley Ergo User Manual

Invacare® Medley Ergo™
Connect both plugs from the hi/lo motors (head end and foot
end) to the control box placed underneath the backrest.
2.
Guide the hi/lo motor wire from the bed foot end AND the wire
from the thigh/leg section motor through the thigh/leg section
motor pipe pin. Make sure the pipe pin is properly locked.
3. Connect the control box to the mains.
4. Run the thigh/leg section to its highest positions .
5.
Place the wire hi/lo motor in the foot end on the hook at the
bed end.
6. Run the backrest to its highest position
7.
Place the wire from the hi/lo motor in the head end, on the two
hooks at the bed end and attach the wire in the backrest motor
pipe pin.
8.
Install the safety clip over the plugs in the control box.
9.
Attach the mains wire in the strain relief that is attached to the
bed frame.
10. Before taking the bed into use, check that all parts run smoothly
and that no motor cables are hanging on the floor or being
squeezed while moving bed sections.
8

3.6.1 Bed with 24 V external power supply

Fasten the short cable A to the control box (a "click" must be
1.
heard)
2. Attach the cable (as described in step 7 in the Wiring section).
3. Connect the short cable B to the transformer cable C.
Connect the transformer 24 V D to the 230 V main socket.
4.

3.7 Installing Aria and Bella side rail

WARNING!
Risk of personal damage
There is a risk of entrapment or squeezing, while
assembling or disassembling the side rail.
– Follow instructions carefully.
– After assembly, check that the side rail has the correct
function.
The installation of Bella wooden side rail and Aria steel side rail is
identical.
Assembling the gliding system
1.
Push the pawl A from the backside, through the glider B and
make sure it locks with an audible click.
2. Do the same for all four pawls in each glider.
Attaching the gliding system and installing the side rail
1. Raise the bed to 1/3 of full height.
2.
Loosen the screw at the bottom of the guides on one of the
bed ends and push the glider halfway up into the guide until it
attaches with an audible click.
1556305-F