Invacare Medley Ergo User Manual page 18

Invacare® Medley Ergo™
Immunity test IEC 60601 test level
Conducted RF
3 V
IEC 61000-4-6
Radiated RF 3 V/m
IEC 61000-4-3
a
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur radio,
AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment
due to fixed RF transmitters, an electromagnetic site survey should be considered. If the measured field strength in the location in which the
medical bed is used exceeds the applicable RF compliance level above, the medical bed should be observed to verify normal operation. If abnormal
performance is observed, additional measures may be necessary, such as reorienting or relocating the medical bed.
b Over the frequency range 150 kHz to 80 MHz, field strengths should be less than [V1] V/m.
At 80 MHz and 800 MHz, the higher frequency range applies.
Recommended separation distances between portable and mobile RF communications equipment and the
medical bed
The medical bed is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The customer or
the user of the medical bed can help prevent electromagnetic interference by maintaining a minimum distance between portable and mobile
RF communications equipment (transmitters) and the medical bed as recommended below, according to the maximum output power of
the communications equipment
Rated maximum output
of transmitter
[W]
0,01
0,1
1
10
100
For transmitters rated at a maximum output power not listed above the recommended separation, distance d in metres (m) can be estimated
using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W)
according to the transmitter manufacturer.
At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
18
Compliance level
3 V
3 V/m
Separation distance according to frequency of transmitter [m]
150 kHz to 80 MHz
0,12
0,37
1,17
3,69
11,67
Electromagnetic environment — guidance
Portable and mobile RF communications equipment
should be used no closer to any part of the medical
bed including cables, than the recommended separation
distance calculated from the equation applicable to the
frequency of the transmitter.
Recommended separation distance:
where P is the maximum output power rating of the
transmitter in watts (W) according to the transmitter
manufacturer and d is the recommended separation
distance in metres (m).
Field strengths from fixed RF transmitters, as determined
by an electromagnetic site survey,
the compliance level in each frequency range.
Interference may occur in the vicinity of equipment
marked with the following symbol:
80 MHz to 800 MHz
0,12
0,37
1,17
3,69
11,67
80 MHz to 800 MHz
800 MHz to 2,5 GHz
b
a should be less than
b
800 MHz to 2,5 GHz
0,23
0,74
2,33
7,38
23,33
1556305-F