Error Messages 925 And 926; Error Messages 941, 942, 950, And 952 - Code 9 On - Digital Equipment DECserver 300 Problem Solving
Hide thumbs
Also See for DECserver 300:
- Hardware installation (109 pages) ,
- Introduction manual (75 pages)
Table of Contents
Advertisement
4.3.5 Error Messages 925 and 926
Local -926- DSR/DTR hardware error on port(s) n
Local -925- Port(s) n may be used with data leads only
Problem
These messages appear together. They indicate a hardware error
with the DSR/DTR circuitry for a particular port. The ports can be
used only with data leads.
Correction: There is no corrective action for this condition.
Return the server to Digial Equipment Corporation for repair or for
replacement.
4.3.6 Error Messages 941, 942, 950, and 952 -
Code 9 on Status Display
The following error messages indicate an Ethernet external loop back error. This
error is also indicated by code 9 in the status display. An Ethernet loopback error
usually indicates that the server is not connected properly to its transceiver. These
messages may also indicate that the transceiver is faulty.
Local -941- Transceiver loopback error
Local -942- Image load not attempted
Local -950- Troubleshooting procedures should be followed
Local -952 - Enter
Ap
to restart self-test
Problem
Problem
Problems on A" Ports
The incorrect Ethernet port has been selected for the Ethernet
loop back test.
Correction: If you are using the Standard Ethernet cable, ensure
that the Ethernet port selector switch is in the OUT position. If
you are using the Thin Wire Ethernet cable, ensure that the selector
switch is pushed IN and that the Thin Wire Ethernet LED is on. If
the Ethernet port selector switch is pushed IN and the Thinwire
LED is not illuminated, contact your local Digital Equipment Cor-
poration sales office for service or replacement.
In standard ThickWire Ethernet mode, there is a problem in the
transceiver cabling between the server and the coaxial cable.
Correction: Check the transceiver cable that runs from the
server to the transceiver, to the DELNI, or to the Etherjack. En-
sure that there is a secure connection at both ends of the cable.
Check the cable for damage. If the cable is damaged, replace the
cable.
4-5
Advertisement
Table of Contents
