Work Area Safety - Genie Z-62/40 TRAX Operator's Manual

First Edition • Second Printing
Work Ar ea Safety
Pictures in this manual may show a boom with tires
and wheels instead of tracks. All safety information
and operating instructions still apply to the Z-62/40
TRAX, even if the picture does not show the tracks.
Electrocution Hazards
This machine is not electrically insulated and will
not provide protection from contact with or
proximity to electrical current.
Line Voltage
0 to 50KV
50 to 200KV
200 to 350KV
350 to 500KV
500 to 750KV
750 to 1000KV
Allow for platform movement, electrical line sway or
sag, and beware of strong or gusty winds.
Part No. 1272873GT
Obey all local and
governmental regulations
regarding required
clearance from electrical
power lines. At a minimum,
the required clearance
contained in the chart below
must be followed.
Required Clearance
10 ft 3.05 m
15 ft 4.60 m
20 ft 6.10 m
25 ft 7.62 m
35 ft 10.67 m
45 ft 13.72 m
®
Z
Do not operate the machine during lightning or
storms.
Do not use the machine as a ground for welding.
Tip-over Hazards
Occupants, equipment and materials shall not
exceed the maximum platform capacity or the
maximum platform capacity of the platform
extension.
Maximum platform capacity
Maximum occupants
The weight of options and accessories, such as
pipe cradles, panel cradles and welders, will
reduce the rated platform capacity and must be
subtracted from the platform capacity. See the
decals with the options and accessories.
If using accessories, read, understand and obey
the decals, instructions and manuals with the
accessory.
™
-62/40 TRAX
Operator's Manual

Work Area Safety

Keep away from the
machine if it contacts
energized power lines.
Personnel on the ground
or in the platform must not
touch or operate the
machine until energized
power lines are shut off.
500 lbs 227 kg
2
13