Reassembly - Graco Pulse Series Repair Manual

F . 4
IG
4. Detach the red and white solenoid
connection (a) (F
Models only.
5. Detach the black and red power
connection (b) (F
NOTE: Be careful not to disturb the white
button board ribbon cable taped to the
bezel housing if reusing the bezel (19).
19
b
F . 5
IG
3A5413F
19
12
20
21
. 5).Pulse and SDP
IG
. 5).
IG
a

Reassembly

1. Connect the black and red power wires
(b) (F
IG
NOTE: Be careful not to disturb the white
button board ribbon cable taped to the
bezel housing.
2. Connect red and white solenoid wires (a)
(F . 5).Pulse and SDP Models only.
IG
3. There are three wire groupings that must
be carefully routed inside the housing.
•
Wrap the red and white solenoid wire (a)
around the solenoid (37) (F
and SDP Models only.
F . 6
IG
12
•
Route the red and black power wires (b)
between the central valve boss (c) and
the battery compartment (d) and under
the foam retainer (F
Service
. 5).
. 7).
IG
. 6). Pulse
IG
37
a
9