Power Cable Replacement - Graco Pulse Series Repair Manual

Power Cable Replacement

1. Remove screws (36) and battery cover
(5).
2. Remove screws (21), o-rings (20) and
bezel (19).
3. Remove Foam (39) and adhesive.
4. Remove the Power Cable (38).
5. Install the new Power Cable (38).
•
Cord is to the left when holding the
metered valve in a normal dispense
position (F
•
The black battery contacts (g) are
installed so that the springs (h) are
located at the top of the installed
contacts (F
F . 10
IG
6. Orient the wires following Reassembly,
Step 3 on page 9.
7. Install new Foam (38) retainer. This
holds the power cable in place. The foam
is shown in the installed position (F
11).
3A5413F
. 9).
IG
. 10).
IG
g
h
F . 11
IG
8. Reinstall the bezel following
Reassembly steps 4 - 8, page 10.
.
IG
Service
11