Download Print this page

Advanced Troubleshooting - Borg & Overstrom u2 Install & Operation Manual

Hide thumbs Also See for u2:

Advertisement

Borg & Overström

Advanced Troubleshooting

30 & 60-Litre Fault Diagnosis
Problem/Report
No Water Dispenses
Only a Small Amount of Water
Dispenses
Cold Water not Cold
Water Leaks
Sparkling Water not Carbonated
Only CO2 is Expelled When
Dispensing Sparkling Water
Sparkling Water is Dispensed in
Splatters.
Only a Small Amount of Sparkling
Water is Dispensed.
Bleeping Noise - 7 bleeps.
Bleeping Noise - 6 bleeps every
15 seconds.
Install & Operation Manual
Possible Cause
Closed water tap.
The connection pipe to the tap is kinked or
pressed shut.
Obstructed filter.
Low inlet water pressure.
Insufficient or obstructed ventilation.
Frozen coil or issues with ice tank.
No power supply.
Filter installed incorrectly.
Internal damage.
Lack of CO2.
Blocked water pump.
No water supply
High CO2 pressure.
Low CO2 pressure.
Refrigeration alarm.
Pump blockage.
26
Suggested Action
Open the tap.
Adjust the path of the pipe to prevent kinks
or compression.
Replace the filter.
Please contact technical support.
Check the dispenser is positioned correctly
with nothing obstructing the ventilation
slots (see pages 12 - 14).
Adjust the thermostat to a higher
temperature. If this fails carry out the ice
tank defrosting procedure (see page 26).
Check the power cable is properly
connected to the dispenser, and that
any electrical components are operating
correctly
Disconnect the power supply, close the
interception valve and replace the filter
(see pages 21 - 22).
Disconnect the power supply, close the
interception valve and contact technical
support.
Replace the CO2 bottle (see page 20).
Disconnect the power supply, close the
interception valve and contact technical
support.
Reduce the CO2 pressure using the pres-
sure reducer.
Increase the CO2 pressure using the
pressure reducer.
Disconnect machine from power and
contact technical support.
Locate and repair accordingly.
GB

Advertisement

loading