Advertisement
30-Litre - Disposable CO2 Bottle Installation
1
Unpack CO2 Regulator and fit elbow fitting
to spigot outlet.
4
Stand the cylinder in a suitable place.
7
It will be necessary to leave the machine for
up to 1 hour for sparkling water to develop,
by absorbing the CO2.
Borg & Overström
2
Attach the regulator to the disposable CO2
bottle, ensuring the small pressure relief
vent in the stem is facing away from you or
anyone else. Ensure the regulator is closed.
Hand tighten securely.
5
After completing the water installation, turn
on the soda power switch and the pump
will run. Allow the carbonation tank to fill.
(The carbonation pump will run for up to 2
minutes).). We recommend between 3.5 - 5
bar (max). Do not exceed 5 bar pressure.
1
hour
Install & Operation Manual
3
Connect the assembled CO2 bottle and
regulator to the 4mm CO2 inlet pipe.
6
5 Max bar
Flush through approximately 10 litres of
water using the sparkling dispense lever,
check and adjust the CO2 pressure
accordingly.
19
10 L
GB
Advertisement
