NEC NP05WK1 Installation And Adjustment Manual page 15

4. Adjust the size of the
projected image.
(1) Loosen the arm unit's two fixing screws.
(2) Holding the slide arm's cap, move forward or
backward to project the image over the entire
screen.
- When installed following the instructions un-
der "Projection Distance and Screen Size",
the image is projected at about the center.
- The slide arm moves a maximum of 600
mm.
- In consideration of change over time of the
position to which the projected image is
adjusted, set so that the projected image
is slightly (about 20 mm) smaller than the
screen.
WARNING
- Do not remove the safety lock screws other than for assembly. Doing so could cause
the slide arm to come off and fall, resulting in injury.
Forward
ENG-14
Safety lock screws
Fixing screws (two)
Backward
Cap