7-INSTALLATION
7.1 Operating Conditions
(see Section 4).
7.2 Space Requirements for Machine Operation
and Maintenance Work
Minimum distance from wall (Figure 7-1):
A = 1.0m. (39.4 inches)
B = 0.7m. (27.6 inches)
Minimum height = 2.7m. (106.3 inches)
WARNING
•
To reduce the risk associated with
mechanical and electrical hazards:
Read, understand, and follow all safety and
operating instructions before operating or
servicing the case sealer.
7.3 Tool Kit Supplied with the Machine
A tool kit containing some tools are supplied
with the machine. These tools should be
adequate to set-up the machine, however,
other tools supplied by the customer will be
required for machine maintenance.
a80b-NA
B
A
Figure 7-1
7.4 Machine Positioning / Bed Height
WARNING
•
To reduce the risk associated with
muscle strain:
−
Use the appropriate rigging and material
handling equipment when lifting or
repositioning this equipment.
−
Use proper body mechanics when
removing or installing taping heads that are
moderately heavy or may be considered
awkward to lift.
1 - Lift the machine with belts or ropes paying atten-
tion to place the belts in the points (Figure 7-2).
To set the machine bed height, do the following:
2 - Adjust machine bed
height. The case
sealer is equipped
with four adjustable
legs. Using a 6mm
hex wrench, loosen
the socket head
screws that hold the
inner leg assem-
bly to the machine
as shown (Figure
7-3). Also refer to
the "Specifi cations"
section.
3 - Lock/tighten screws.
4 - Repeat the
operation adjusting
all legs equally.
(It is not necessary
to fi x or anchor the
machine to the fl oor).
17
Figure 7-2
Figure 7-3
2011 April