NOTE:
The 12500 routing switches provides a command line interface (CLI). For more information about the
•
HP 12500 Routing Switch Series Fundamentals Configuration Guide.
CLI, see
•
The output depends on your switch model.
Verification after power-on
HP recommends that you check the following conditions after the switch is powered on:
The cooling system is operating. You should be able to hear fan rotation noise and feel air being
•
blown out.
All the system LEDs on the MPUs are functioning properly.
•
Table 15 LED status when the switch operates normally
Module
MPU
LPU
Switching fabric module
Power monitor module
Fan
Connecting the switch to the network
TIP:
After connecting the switch to the network, you can use the ping or tracert command to check the
interoperability between the switch and network. For more information, see
Series Network Management and Monitoring Command Reference
Connecting the switch to the network through the AUX port
You need an AUX cable when configuring a switch with the remote modem dial-up approach.
LED
SFC (red and green)
LC (red and green)
FAN (red and green)
PWR (red and green)
ACT (green)
RUN (red and green)
RUN (red and green)
RUN (red and green)
RUN (green)
MAJOR (red)
MINOR (yellow)
RUN (green)
ALM (red)
56
Status
Flashing green
Flashing green
Flashing green
Flashing green
Steady on
Flashing green
Flashing green
Flashing green
Steady on
Off
Off
Flashing
Off
.
HP 12500 Routing Switch