Power Components - HP 12500 Series Installation Manual

Table 39 OAA card specifications
Model
LST1FW2A1
LST1FW3A1

Power components

Select AC or DC power components according to the power supply mode of your switch.
Choose power supplies based on your actual needs. Make sure the maximum output power of the
•
power supplies exceeds the system power consumption (HP recommends reserving a certain power
de-rating value). For the maximum output power of a single power supply, see
HP recommends you to configure N+1 or N+M power supply redundancy.
•
To use AC power supply, select the specific 16 A AC power cords. For the 16A AC power cords
•
used in different countries or regions, see
Table 40 Power system ordering guide
Model
PSE9000-A1
PSE9000-D
Interfaces
•
One console port
•
One CF card slot, supporting a 256M, 512M, or 1G CF
card
•
Two USB ports
•
Two 10/100/1000 BASE-T copper ports
•
Two GE combo interfaces
•
One console port
•
One CF card slot, supporting a 256M CF card
•
Two USB ports (reserved for hardware, not supporting
software)
•
Two GE combo interfaces
Power
supply Power components
mode
AC power frame
PEM
AC
Power monitor module
AC power supply
DC power frame
DC Power monitor module
DC power supply
Table 42.
Configured quantity
•
1 for the 12504 or 12508
•
2 for the 12518
One is required for each power frame
One is required for each power frame
•
6 at most for the 12504 or 12508
•
12 at most for the 12518
•
1 for the 12504 or 12508
•
2 for the 12518
One is required for each power frame
•
6 at most for the 12504 or 12508
•
12 at most for the 12518
106
Supported interface
modules
GE SFP modules
GE SFP modules
Table 41.