Reset Button; Resetting The Default Settings - Guntermann & Drunck ControlCenter-Digital-288 Installation And Operation Manual

Reset button

The controller card CCD-Control-Card provides a Reset button between the LEDs and
the Bus interfaces.
This button allows you to reset the default settings and disable the netfilter rules.
NOTE:
To prevent you from pressing the button by accident, use a thin, pointed
object to press the button.

Resetting the default settings

Pressing and holding the button during the booting process resets the default settings
of the matrix switch.
NOTE: After the function has been carried out, the default settings of the matrix
switch do apply again.
How to reset the default settings of the matrix switch:
1. Turn off all power packs of the matrix switch.
2. Press and hold the Reset button.
3. Keep the button pressed and turn on at least one of the device's power supply
modules.
4. Release the button when the green Switch-LED starts blinking.
NOTE: You can also use the Config Panel web application to reset the default settings.
G&D ControlCenter-Digital-288 · 19
Reset button