Power Supply; Network Interfaces - Guntermann & Drunck ControlCenter-Digital-288 Installation And Operation Manual

 Connect the target computers to the different target modules.
 Connect the Transmission interfaces of the individual target modules to one
Dynamic Port of a compatible IO card..
IMPORTANT:
UC variants of target modules provide two Trans. interfaces to con-
nect a computer to two different KVM matrix systems. Connect only one of the tar-
get module's Trans. interfaces to this matrix switch!

Power supply

AC DC
Power ×: Connect one of the supplied power cables for each installed power supply
module. Connect the power cable with a power socket and turn on the power switch.

Network interfaces

NOTE: Connect the matrix switch to one or two local networks to configure it via
the Config Panel web application and to use the enhanced network functionalities
(for example authentication against directory services, time sync via NTP server,
netfilter or syslog).
Network A
Network A: Plug in a category 5e (or better) twisted-pair cable, which is available as
accessory.
Connect the other end of the cable to a network interface of the local network.
Plug in a category 5e (or better) twisted-pair cable, which is available as
Network B:
accessory.
Connect the other end of the cable to a network interface of the local network.
USB
Network B DisplayPort
Bus IN
RS232 Service
Status
Fail Ctrl
Ident.
Fail Comm.
Bus OUT
G&D ControlCenter-Digital-288 · 15
Installation