Installing Or Replacing Components; Installing Or Replacing Io Cards - Guntermann & Drunck ControlCenter-Digital-288 Installation And Operation Manual

 The 18 ports of each
ules of the KVM system.
 Each fan board (4) is equipped with ten fans. The fans of the Fan IN board draw the
outside air into the device. The fans of the Fan OUT board blow the air out of the
device.
To protect the components in the housing from dust, a filter is placed in front of
the fans of the Fan IN board.
IMPORTANT:
Change the filters regularly. The time between changing the filter
depends on how much dust the devices are exposed to:
 Strong exposure to dust:
 Moderate exposure to dust:
 Light exposure to dust:
Check the filter condition regularly. Tap the filter or use light blows of compres-
sed air to clean the filter. Change the filter at the latest after six months.
 Up to three power supply modules (5)
at least two power supply modules, you can replace one of them during operation.
NOTE: By distributing the load, power is supplied to all active power supply
modules.

Installing or replacing components

Installing or replacing IO cards

IO cards can be installed (hot plug) or replaced (hot swap) during operation.
The IO Card
CCD-IO16-Card-Fiber
comply with laser class 1.
They meet the requirements in accordance to
U.S. CFR 1040.10 and
Mind the following instructions when dealing with laser beams:
 Avoid direct eye exposure to beam on page 4
 Always connect optical connections or cover them with protection caps on page 4
 Only use G&D certified transmission modules on page 4
IO card (3) let you connect the user modules or the target mod-
1 month
3 months
6 months
provide power to the matrix switch. If you use
uses components with laser technology which
1040.11 .
Modular design of the matrix switch
as well as
EN 60825-1:2014
G&D ControlCenter-Digital-288 · 9