Troubleshooting - Promac 347V Operating Instructions And Parts Manual

Troubleshooting

Fault
Bad Cuts (rough)
Blade is Twisting
Unusual Wear on
Side/Back of Blade
Probable Cause
26. Blade speed is too high for feeding
pressure.
27. Blade is too coarse.
28. Blade is binding in the cut.
29. Blade tension too high
30. Blade guides worn
31. Blade guide bearings not adjusted.
32. Blade guide bearing bracket is
loose.
26. Reduce the blade speed and feed
pressure.
27. Replace with finer blade.
28. Decrease feed pressure.
29. Decrease tension on Blade
30. Replace blade guides.
31. Adjust blade guide bearings.
32. Tighten blade guide bearing bracket.
15
Suggested Remedy