Table of Contents
Advertisement
Vitotronic 300, GW6B Operating
Select Heating Circuit
Room Temperature
Central Heating - Single boiler system control
Heating can, if necessary, be split over several heating
circuits. From the factory, heating circuits are designated
1, 2, 3 in the header.
H If you are controlling several heating circuits,
for all central heating settings, first select the heating
circuit to which the change should apply.
H If you are only controlling one heating circuit, this
option is not available.
Tap the header and select heating circuit 1, 2 or 3.
Note: Further information can be found in chapter
"Terminology" in this manual.
Setting the standard room temperature for the selected
heating circuit
Factory setting: 68°F (20°C)
Setting range: 37 to 99°F (3 to 37°C)
From the home screen tap the following buttons:
1. Heating circuit 1, 2 or 3 in the header for the required
heating circuit
2.
for the required value
3.
to confirm
Setting reduced room temperature
Factory setting: 64°F (18°C)
Setting range: 37 to 99°F (3 to 37°C)
From the home screen tap the following buttons:
1.
2.
3. "Heating circuit 1", "Heating circuit 2" or "Heating
circuit 3" as the required heating circuit
4. "Reduced room temp setpoint"
5.
for the required value
6.
to confirm
Central heating with this temperature:
H Between the time phases for central heating with
standard temperature
H In the holiday program
19
Advertisement
Table of Contents
