Invicta AKIMIX Reference page 31

Whichever method is used (normal output or long period), ensure that the initial load of wood is properly lit and that the flame is
If not, move the output regulator to the
maintained.
catch.
Ensure that flames are present during combustion of the volatile fraction of the wood, to avoid the stove or flue sooting-up and
emissions which might be harmful to health or the environment.
Post combustion activated = GOOD
Stove hot and clean
"
Glass is clean
Clean
air

Regulator settings:

Output Regulator:
The output regulator may be used when using either logs or granules. Instructions for use with granules are detailed below.
USING WITH WOOD GRANULES»
Lighting position: When using LOGS, setting the output regulator above "normal output" increases airflow for lighting.

The regulator should not be left in this position for more than 30 minutes, doing so may damage the appliance and its environment. The
appliance should remain under supervision during lighting.

Secondary air regulator:
to be adjusted only with higher than recommended airflows (see above) This setting can be changed in this case to obtain a satisfactory
output. Once adjusted, do not change the secondary airflow setting to modify the output of the appliance. Use the output regulator to
increase or decrease output.

Post-combustion setting
The regulators may be very hot. Always use the heat resistant glove supplied with the appliance when touching the regulators.
Français – English - Deutsch
DT, le 18/06/2019
AKIMIX Wood Stove
"
Air post-
combustion
Is used to switch the appliance from
The secondary air regulator should remain open at all times to achieve complete burning. This setting needs
The secondary air regulator should remain open at all times to achieve complete burning.
" "
lighting position to increase airflow and allow the wood to
Combustion without flames = BAD
Stove cold and dirty
"
Glass is
dirty
Bed of
embers
" " "
normal output to usage for long periods
Reference 6190 34
"
"
Page 31 sur 60
–
«
2