First Use - Invicta AKIMIX Reference

To use granules for
heating
1- Turn the dial clockwise
and switch to granules
2 - Set the post-
combustion air regulator to
closed

First use: Set the rear power switch to

Lighting when using granules:
o
Set the airflow regulators to
o
Place some crumpled paper (avoid glossy paper) or
minimum. Light the fire and close the hearth door.
the appliance should remain under supervision.
o
After several minutes, check that the granules are alight.
o
Choose the output level required using the dial = see below
Lighting is "manual" and thus requires attention.
It is important to check whether flames are present once lit: if there no flames, and the wood starts to smoke, the
stove should be stopped.
Keep an eye on the stove for around 30 minutes until certain that it is operating correctly with an automatic supply of
granules.

Setting the type of granules: Set the dial to the
dial is fully open, power output is 6kW.
Sleep mode
Français – English - Deutsch
DT, le 18/06/2019
AKIMIX Wood Stove

First use:

3 - Set the output regulator to
"granules"
" "
ON
" "
Granules (see diagram page 11)
"
fire-lighters
It may be useful to leave the hearth door open slightly while lighting, but
" "
ON position. To increase output, turn the dial clockwise (see diagram below). When the
4 - Turn the secondary
airflow regulator to closed
"
on the grid and a handful of granules, turn the dial clockwise to

Green ON = granule feed is operational
OFF = stove is off

Red ON = granule feeder is working
OFF = granule feeder screw is blocked
Power: Autonomy:
≈
3.5 kW
≈
6.5 kW
Reference 6190 34
17 h
8 h
Page 34 sur 60