Modular Service Display Msd 1 101 - Leuze electronic BPS 34 Technical Description

Description
3.6

Modular Service Display MSD 1 101

The modular service display is used to display the reading and operational data on the one
hand, and as simple access to the service interface on the other. The RS 232 service inter-
face of the BPS 34 is tapped in this case and is made available at the 9-pin sub D connector
of the MSD (for further information see page 15).
To connect to the MS 34105, an 8-pin cable (M12) with a length of 2m is used (see chapter
5 "Accessories / Order Designation").
Using the maintenance display, new settings for the BPS can be trialled quickly and easily,
without having to project these settings via the Profibus. Once the optimal settings have
been found, which are to be adopted for the standard operation, these must be included in
the project in order for them to become permanently active.
Notice!
The BPS has a parameter memory in which all project settings are stored. When switching
back from maintenance mode to standard mode, the settings specified in maintenance
mode are overwritten by the settings stored in the parameter memory.
10 BPS 34
Leuze electronic
Leuze electronic