Powering The Unit On - Filament Innovations BFP-ICARUS Series Operating Manual

Powering the Unit On

The ICARUS units run on 110VAC current, this is standard household
electricity found in the USA. The addition of the 110VAC heated bed can draw up
to 10 amps during initial heating. Please choose an outlet that does not have a
high amperage draw to ensure no breakers pop. Using the supplied 110VAC
power cord, plug the designated end into an outlet and the other into the top of
the Control Case into the Fused Power Switch. The switch will light up when there
is power flowing to the primary power switch and the switch is turned on. Please
see the reference pictures below.
Fused Power Switch Turned On:
21
Last Revised on 4/25/19