Table of Contents
Advertisement
Once inside the crate, you will find the 3D Printer and a wrench screwed to
the bottom of it (shown below). This wrench is used to raise the rubber stabilizer
feet so the wheels can make contact with the ground and the printer can be
pushed around.
Wrench:
Once inside the crate, locate the heavy duty L brackets securing the printer
to the pallet. Please remove the brackets and any hardware accompanying them.
From here, you can use the wrench pictured above to pull the stabilizer feet back
into the casters so the wheels are touching the floor of the crate. The orange
circle inside the caster is turned to move the stabilizer feet up and down.
Caster Adjuster:
Last Revised on 4/25/19
8
Advertisement
Table of Contents
