Table of Contents
Advertisement
Quick Start Guide
The following quick start guide allows you to check and monitor the
progress of you unboxing your printer and getting ready for the first print. It is
recommended to check each step off here to ensure everything is done in order
and correctly.
1. Disassemble the crate using a power drill and crowbar.
2. Remove the L brackets from the bottom of the printer that attach it to the
crate, and adjust the casters so the wheels are on the pallet.
3. Remove the machine from the pallet by gently rolling it off and move the
machine to the general area where it will be used.
4. Remove the shrink wrap from the machine and locate the tool box and
shipping box with accessories inside the printer.
5. Level the machine using the included bubble level.
6. Remove the 16mm shaft collars from the four Z rods that are located under
the aluminum print bed, there is one collar per rod.
7. Cut and remove the two zip ties that hold the X carriage next to the Y axis,
these will be next to the extruder.
8. Using the bubble level, place it under the aluminum print bed and level the
bed by manually turning one of the ballscrews.
9. Plug the 110VAC cord into the wall and the machine, turn the blue rocker
switch on (located next to the 110VAC plug), and flip the red toggle switch.
The unit should now be powered on.
10. From the touch screen, Home All axes and then perform tilt bed
compensation via the Macro button: Macro – Bed Leveling - Tilt
Compensation (Left to Right).
11. Attach the spool holder to the left side of the machine using the included
Allen Keys.
12. Connect to a Wifi Network following the instructions in this manual under
the Wifi Connectivity section. Check that you can connect to the Duet Web
Control interface afterward. Install the webcam now if desired.
13. Install the slicer profiles, included in the MicroSD card, and happy printing!
Last Revised on 4/25/19
3
Advertisement
Table of Contents
