Removing Aluminum Print Bed Supports - Filament Innovations BFP-ICARUS Series Operating Manual

After Adjusting the Casters:
All four sides of the printer should be within an acceptable leveling range
by having the leveling bubble between the two lines. At this point, you can now
cut and remove the two zip ties holding the X axis to the Y axis near the hotend.
The X and Y axis are zip-tied together to prevent shipping damage.

Removing Aluminum Print Bed Supports

There will be four 16mm shaft collars on the bottom of the aluminum bed
plate – one on each 16mm vertical smooth rod for the Z axis. This is to ensure the
bedplate does not shift or move during shipping. Simply loosen the one allen key
bolt, one on each shaft collar, and allow it to fall to the bottom of the printer.
Please note that we do use different vendors for these shaft collars and the one
on your machine may look different.
Last Revised on 4/25/19
19