Bed Height Adjustment and Automatic Leveling
Keeping a level bed is critical for accurate 3D Printing. Every ICARUS unit
comes equipped with mesh bed leveling to ensure a flat bed. While your bed
leveling and Z-offset is set by the Filament Innovations staff, we need to once
again check that no damage occurred during shipping.
Step One – Every ICARUS unit ships with "light" tension springs with locks
nuts. Please check that all four are on the bed plate, one in each corner. These are
factory set and your print should arrive level if all are present. The color of the
springs you receive may vary.
Last Revised on 4/25/19
24