Cura has a second tab for the nozzle diameter and filament diameter to be
entered.
There is no special gCode settings for the Extruder 1 tab.
Simplify3D
o Under File - Import FFF Profile select the profile that is relevant to
your machine and import it (ICARUS or ICARUS-X).
o Check that the Start and End gCode sequences, under Edit Process
Settings - Scripts, is correct. If it is not, then copy and paste the
scripts in.
The Starting and Ending gCode is the same for Cura and Simplify3D.
We purposefully have the printing speed set at 50-75 mm/s for the unit, as
this is a good entry level speed for new 3D Printing users. Advanced users can
increase the speed. Please note we offer these profiles as starting points,
therefore they will need to be modified to accommodate various STL files
(overhangs, support, etc).
Last Revised on 4/25/19
44