Wiznet W7500S2E Series User Manual page 28

IP_MODE (IP configuration mode)
Command format
AT+IP_MODE?
AT+IP_MODE=<parameter>
Response [IP_MODE] Value is:<value>\r\nOK\r\n
Command: AT+IP_MODE=1\r\n
Example
Response: [IP_MODE] Value is:1\r\nOK\r\n
In static IP mode, the IP address, gateway, subnet mask and DNS server address are required
configure by the user. In DHCP mode, device will get all above IP parameters from the DHCP server.
IP (IP address)
Command format
AT+IP?
AT+IP=<parameter>
Response [IP] Value is:<value>\r\nOK\r\n
Command: AT+IP=192.168.1.88\r\n
Example
Response: [IP] Value is:192.168.1.88\r\nOK\r\n
The IP address has format in human-readable notations for IPv4, such as 172.16.254.1; maximum
length of IP address is 15 bytes. This value is effective only if IP configuration mode (IP_MODE) is in
"Static IP mode".
MARK (Subnet mask)
Command format
AT+MARK?
AT+MARK=<parameter>
Response [MARK] Value is:<value>\r\nOK\r\n
Command: AT+MARK=255.255.255.0\r\n
Example
Response: [MARK] Value is:255.255.255.0\r\nOK\r\n
The subnet mask format in human-readable notations for IPv4, such as 255.255.255.0; maximum
length is 15 bytes. This value is effective only if IP configuration mode (IP_MODE) is in "Static IP
mode".
GATEWAY (Gateway)
Command format
AT+GATEWAY?
AT+GATEWAY=<parameter>
Response [GATEWAY] Value is:<value>\r\nOK\r\n
Command: AT+GATEWAY=192.168.1.1\r\n
Example
Response: [GATEWAY] Value is:192.168.1.1\r\nOK\r\n
The gateway IP address has format in human-readable notations for IPv4, such as 172.16.254.1;
maximum length of IP address is 15 bytes. This value is effective only if IP configuration mode
W7500S2E user manual
W7500S2E serial to Ethernet module
Parameters
Nil
0: Static IP mode (default)
1: DHCP mode
Parameters
Nil
Default: 192.168.1.88
Parameters
Nil
Default: 255.255.255.0
Parameters
Nil
Default: 192.168.1.1
25
Usage
Read
Set
Usage
Read
Set
Usage
Read
Set
Usage
Read
Set