Switching From Cli To Acli For A Dual Cpu (Non-Ha) From Factory Defaults; Switching From Cli To Acli For A Dual Cpu (Non-Ha) From Existing Configurations - Avaya 8800 User Interface Fundamentals

ACLI procedures
Switching from CLI to ACLI for a dual CPU (non-HA) from
factory defaults
The savetostandby flag is enabled after you upgrade a dual CPU, not in high availability mode
(non-HA), from the CLI to ACLI and from the ACLI to CLI from both factory defaults and existing
configurations.
Procedure steps
1. Set the factory defaults flag on the switch and save the boot configuration.
2. Boot the secondary SF/CPU in ACLI mode. The secondary SF/CPU starts in ACLI
3. Boot the primary SF/CPU in ACLI mode.
Switching from CLI to ACLI for a dual CPU (non-HA) from
existing configurations
Use the following procedure to change a dual CPU from CLI to ACLI from an existing
configuration.
Procedure steps
1. Save the configurations in ACLI mode.
2. Enter the following command:
3. Boot the secondary SF/CPU first and then boot the primary SF/CPU.
44 User Interface Fundamentals
mode.
Both CPUs are now in ACLI mode.
The following is an example:
save config file acli.cfg mode acli
config boot flags acli true
Comments? infodev@avaya.com
July 2013