Switching From Cli To Acli For An Ha-Cpu From Factory Defaults; Switching From Cli To Acli For An Ha-Cpu From Existing Configurations - Avaya 8800 User Interface Fundamentals

ACLI procedures
3. Boot the secondary SF/CPU first and then boot the primary SF/CPU.
Switching from CLI to ACLI for an HA-CPU from factory
defaults
The HA flag and savetostandby flag are enabled after you upgrade an HA-CPU from the CLI
to ACLI and from the ACLI to CLI from both factory defaults and existing configurations.
In HA-SETUP, you must boot both the primary SF/CPU and secondary SF/CPU; otherwise,
one is in CLI mode and other is in ACLI mode. When you toggle from ACLI to CLI, table
synchronization does not occur if one SF/CPU is in CLI mode and the other SF/CPU is in ACLI
mode.
Procedure steps
1. Set factory defaults flag on the switch and save the boot configuration.
2. Boot the secondary SF/CPU in ACLI mode.
3. Boot the primary SF/CPU in ACLI mode.
Switching from CLI to ACLI for an HA-CPU from existing
configurations
Use the following procedure to change an HA-CPU from CLI to ACLI from an existing
configuration.
Procedure steps
1. Save the configurations in ACLI mode.
2. Enter the following command:
46 User Interface Fundamentals
no boot config flags acli
The secondary SF/CPU comes up in ACLI mode.
Both the secondary SF/CPU and primary SF/CPU are now in ACLI mode.
The following is an example:
save config file acli.cfg mode acli
Comments? infodev@avaya.com
July 2013